|
|
|
|
 |
 
|
|
BMW Garage | BMW Meets | Register | Today's Posts | Search |
|
|
BMW 3-Series (E90 E92) Forum
>
325I doesnt start after valvetronic sensor replacement
|
 |
| 03-08-2026, 12:38 PM | #1 |
|
Registered
6
Rep 3
Posts |
325I doesnt start after valvetronic sensor replacement
Hello, earlier today i opened the valve cover, replaced the sensor and torqued the valve cover back again.
Gaskets were replaced a week ago so i was not worried about that. But when i tried to turn the car on it didnt want to. The rpm needle is moving and it goes up to about 1000 rpm and then down to zero. I tried multiple times up to 30 sec without it turning on. Has anyone had this exact problem? My valevtronic motor is completely broken (the spindle is broken clean off), but i have started the car without the motor plugged in before. PLEASE HELP i am a first time bmw owner. Ive owned this car for about two weeks and i have spend 0 seconds over 60 mph. It has been in limp mode since i bought it and now it dpesnt even start. |
 |
| Bookmarks |
|
|
